Skip to content

Bart Slinger

Electronics and Software

  • CX-10 Mini Quadcopter
  • Paparazzi Autopilot
  • Electronics
    • NRF24LU1 USB Dongle
    • KlikAanKlikUit
    • LABPS3005D USB Power Supply
    • STM32CubeMX
  • Test Driven Development
  • About

Category Archives: CX-10 Mini Quadcopter

CX-10 wins special award at IMAV 2015

19 Sep

Last week I participated with the MAVLab team from TU Delft at the International Micro Aerial Vehicle Conference and Flight Competition. The awarded points increased exponentially for smaller sized drones. Therefore we participated in two mission elements with a CX-10, … Read More »

CX-10 Mini Quadcopter 4 Comments

Computer Controlled CX-10

18 Aug

The goal is to control the CX-10 (without custom firmware) from a computer. This is accomplished by connecting some wires from the transmitter to an Arduino. The potentiometers are removed from the transmitter and replaced by wires which connect to … Read More »

CX-10 Mini Quadcopter 5 Comments

Debugging STM32 from QtCreator

4 Jul

In a previous post it was already shown how to setup Eclipse for debugging STM32 applications. However, since I’m a big fan of QtCreator IDE, I figured out how to set it up in this as well. This does not … Read More »

CX-10 Mini Quadcopter, QtCreator 7 Comments

Blinky with CMSIS, STM32 HAL and debugger

16 Jun

To program the CX-10 with CMSIS and STM32 Hardware Abstraction Layer (HAL), the same hardware preparations are required. Installing Eclipse and GNU ARM development extension Follow the steps from this link: http://gnuarmeclipse.livius.net/blog/plugins-install/ Create a new project for CX-10 development Go … Read More »

CX-10 Mini Quadcopter 1 Comment

Getting to Blinky with CX-10

10 Jun

As with all embedded systems, getting to blinky is the first thing you want. Please refer to the previous post on preparing the hardware to have a programmable setup with the flash memory of the processor cleared. Libopencm3 Most of … Read More »

CX-10 Mini Quadcopter Leave a comment

Hardware preparations CX-10

10 Jun

The general steps are as follows: Solder wires to the board. Configure the STLink of the Discovery board. Apply external power to the Vdd pin of the SWD. Clear flash memory of the chip. The following items are required: CX-10 … Read More »

CX-10 Mini Quadcopter 3 Comments

Recent Posts

  • Over-engineering a Mun landing in Kerbal Space Program
  • STM32 CubeMX “Timer + ADC + DMA”
  • Bluetooth rotary phone
  • IOTA transactions with TREZOR hardware
  • STM32CubeMX, CMake and QtCreator

Archives

  • January 2021 (1)
  • January 2019 (1)
  • August 2018 (1)
  • November 2017 (1)
  • February 2017 (1)
  • January 2017 (1)
  • November 2016 (1)
  • August 2016 (1)
  • April 2016 (1)
  • March 2016 (2)
  • December 2015 (2)
  • September 2015 (1)
  • August 2015 (2)
  • July 2015 (2)
  • June 2015 (3)

External Links

  • http://www.mavlab.info http://www.mavlab.info
  • TXBoxy
© 2023 Bart Slinger
Powered by WordPress / Theme by Design Lab
  • Privacy Policy