Electronics and Software
This is yet another project with the versatile ESP-8266 WiFi chip. I have an ARDrone2 and a Turnigy 9X transmitter (flashed with the awesome ER9X firmware). The ARDrone2 is usually controlled with a phone or tablet over WiFi. This gives … Read More »
I finally found some time to finish the soldering station and it works really well(er)! Power Supply As said in part 1, I used an old computer power supply. I removed it from the original case to adapt it to … Read More »
I’m still using my 20$ soldering station which I use since I got started with electronics. Now it’s time for an upgrade. Weller® quality is exceptional, but also exceptionally expensive. Some guys designed an open source Weller® soldering station which … Read More »
Heineken sells this speakerkratje for just under 10 euros. It has a nifty audio amplifier based on inductance from your phones speaker. For no good reason I decided to add a bluetooth receiver. Speakerkratje This is the speakerkratje: The bottom … Read More »
Last week I participated with the MAVLab team from TU Delft at the International Micro Aerial Vehicle Conference and Flight Competition. The awarded points increased exponentially for smaller sized drones. Therefore we participated in two mission elements with a CX-10, … Read More »
We have an old fashioned gas oven which does not have a thermometer inside. I bought a cheap digital thermometer from banggood for just over 5 euros. That’s already very nice, but would it not be cool if the temperature … Read More »
The goal is to control the CX-10 (without custom firmware) from a computer. This is accomplished by connecting some wires from the transmitter to an Arduino. The potentiometers are removed from the transmitter and replaced by wires which connect to … Read More »
This describes a concept for a new SDLogger, so we can discuss it before it is actually implemented. New logger uses the previously committed sdcard_spi peripheral. It also uses pprzlog_transport for transporting messages. The logger itself is a device to … Read More »
In a previous post it was already shown how to setup Eclipse for debugging STM32 applications. However, since I’m a big fan of QtCreator IDE, I figured out how to set it up in this as well. This does not … Read More »
To program the CX-10 with CMSIS and STM32 Hardware Abstraction Layer (HAL), the same hardware preparations are required. Installing Eclipse and GNU ARM development extension Follow the steps from this link: http://gnuarmeclipse.livius.net/blog/plugins-install/ Create a new project for CX-10 development Go … Read More »